Extra-long Well proportioned, hardened, properly tempered, and have a knurled grip For following long cotter pins and the like into holes with out hindrance

Extra-long Well proportioned, hardened, properly tempered, and have a knurled grip For following long cotter pins and the like into holes with out hindrance

Special collet design with tapers at both ends, providing maximum clamping surface Smaller body diameter than the chuck which allows fast opening and closing Set of all four sizes in a protective case

Special collet design with tapers at both ends, providing maximum clamping surface Have a smaller body diameter than the chuck, which allows fast opening/closing and rapid rotation between the thumb and finger when used on small work

Special collet design with tapers at both ends, providing maximum clamping surface Have a smaller body diameter than the chuck, which allows fast opening/closing and rapid rotation between the thumb and finger when used on small work

Special collet design with tapers at both ends, providing maximum clamping surface Have a smaller body diameter than the chuck, which allows fast opening/closing and rapid rotation between the thumb and finger when used on small work

Jaws on all are hardened and with a few turns of the binding nut, a firm grip may be obtained Insulating PVC handle which is octagon shaped, preventing them from rolling when laid down Hole extends through the full length of the handles so that wires of...

Jaws on all are hardened and with a few turns of the binding nut, a firm grip may be obtained Insulating PVC handle which is octagon shaped, preventing them from rolling when laid down Hole extends through the full length of the handles so that wires of...

Jaws on all are hardened and with a few turns of the binding nut, a firm grip may be obtained Handles and binding nuts are nickel-plated Hole extends through the full length of the handles so that wires of any length and any diameter up to the full size...

Reversible collets with two size capacities at each end Both ends of each chuck are beveled, providing "back support" Knurled handle and binding nut One chuck holds 0" to 0.031" and 0.093" to 0.125" diameter tools Other chuck holds 0.031" to 0.062" and 0...

Jaws on all are hardened and with a few turns of the binding nut, a firm grip may be obtained Handles and binding nuts are nickel-plated Hole extends through the full length of the handles so that wires of any length and any diameter up to the full size...

Made of specially selected steel, hardened and properly tempered Well proportioned, nicely finished and have a knurled finger grip Points are ground at the proper angle to give maximum service, and the tips are accurately centered